Thingiverse
HDZero 1W Freestyle VTX protector
por PeneloPPE
15
Descargas
8
Likes
0
Makes
It started by modifying some STL.. like usual it ended up being a full remake lol..
Protect the plugs and wire harness, has an opening to route it through.
The part where the MIPI comes out is to fit my own ergonomic need, it's probably not the best design but I have limited space ;) I am personally putting liquid tape after inserting the MIPI cable in the slot.
Not practical at all to update in the future, but you if you cut the UFL cover part it would be easier to acces the update plug afterward.
V1 : has cutout to leave a bit more space but it becomes thin ( Again my needs )
V2 : no cut-out , a bit more solid and much easier to print
TPU, Cura 5.xx, 0.2mm layer height
Protect the plugs and wire harness, has an opening to route it through.
The part where the MIPI comes out is to fit my own ergonomic need, it's probably not the best design but I have limited space ;) I am personally putting liquid tape after inserting the MIPI cable in the slot.
Not practical at all to update in the future, but you if you cut the UFL cover part it would be easier to acces the update plug afterward.
V1 : has cutout to leave a bit more space but it becomes thin ( Again my needs )
V2 : no cut-out , a bit more solid and much easier to print
TPU, Cura 5.xx, 0.2mm layer height
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
