Thingiverse
HDZero Lux camera 14mm adapter
door Fourflies
7
Downloads
9
Likes
1
Makes
This adapter allows one to use an HDZero Lux camera in a common 14 mm wide FPV camera mount, eg. compatible with a Happymodel Crux3 canopy, plus many others.
The photographed samples were printed by JLCPCB in PA12 on their MJF printers. Approximately 0.1 grams of mass. Untested in any other printers. Feedback appreciated!
The screw holes are only partial, so you'll need to drill them out the rest of the way. I've done this as I believe a drilled hole is stronger than a printed hole, and it's difficult to print holes smaller than 1.0 mm diameter.
The photographed samples were printed by JLCPCB in PA12 on their MJF printers. Approximately 0.1 grams of mass. Untested in any other printers. Feedback appreciated!
The screw holes are only partial, so you'll need to drill them out the rest of the way. I've done this as I believe a drilled hole is stronger than a printed hole, and it's difficult to print holes smaller than 1.0 mm diameter.
Fourflies publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
