Thingiverse
Header Pin Back Block
by BrianM
41
Downloads
24
Likes
0
Makes
A simple design to create a back shell for Polarized Header Pins
so they can be used in-line.
Script allow selection of several parameters but the important
ones are;
Number of Pins
Length of back shell
Radius of hole
I have tested 2, 3 and 4 pins but haven't tried any thing bigger.
Solder the wires to the pins, heat shrink for support, then a little epoxy to hold it all in place.
Print and Enjoy.
so they can be used in-line.
Script allow selection of several parameters but the important
ones are;
Number of Pins
Length of back shell
Radius of hole
I have tested 2, 3 and 4 pins but haven't tried any thing bigger.
Solder the wires to the pins, heat shrink for support, then a little epoxy to hold it all in place.
Print and Enjoy.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!