Thingiverse
Headlamp battery holder
door gaddman
2
Downloads
1
Likes
0
Makes
Battery holder for a headlamp. Two parts - the bracket which is designed to attach to elastic webbing, and a cage to hold the battery. Press fit and glue together.
Recommended improvements:
* The tolerance was a bit tight and I had to file down the bracket to press into the guage - take 0.1mm off each side of the square blocks on the bracket.
* It's a little sharp for something you wear - round all the corners.
* The spacing of the mesh grid isn't quite even vertically and horizontally, so it can only hang vertically below the bracket - even up the spacing and you could have the choice.
Recommended improvements:
* The tolerance was a bit tight and I had to file down the bracket to press into the guage - take 0.1mm off each side of the square blocks on the bracket.
* It's a little sharp for something you wear - round all the corners.
* The spacing of the mesh grid isn't quite even vertically and horizontally, so it can only hang vertically below the bracket - even up the spacing and you could have the choice.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!