MakerWorld
Electronics
Go to Model
Headphone and Controller Stand
58
Downloads
41
Likes
17
Makes
This is a design I have been working on that includes a headphone stand and controller stand. The stand has a place for LEDs to give your gaming space that added spice you are looking for. When building, thread the LEDs up the side of the arch next to the hole in the bottom of the base first.All of the pieces easily fit together but glue will be needed to hold it in place. Please thread the LEDs before gluing anything. If you do not, it will be very hard to thread the LEDs properly. This is a first draft of the design so there are already some changes I plan to make.I'd like to hear any advice or recommendations before I make any changes. Lastly, please ENJOY and I hope this fits your needs!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
