Thingiverse
Headphone Headset Hanger
von SpeedRacer87
14
Downloads
9
Likes
0
Makes
I didn't especially like any of the models as they did not specify size and always had holes for mounting instead of Command Strips.
MUST BE SCALED UP 2540% BECAUSE OF SOLIDWORKS PROGRAMMING!
Dimensions/Fitment: This hanger is 1-7/8" wide so it will hold any Headset with a band of that size or smaller the diameter of the curve is Ø4-3/4" because that is the diameter of my Logitech Pro X headset. It will fit most of any headset.
Printing: I used Cura, 3 walls, 20% Infill, 0.2 layer height, and Tree Supports to hold the front lip just to be sure it would look good and it used barely any filament compared to regular supports in Cura. For some printers, it may be unnecessary (Don't take my word for it).
MUST BE SCALED UP 2540% BECAUSE OF SOLIDWORKS PROGRAMMING!
Dimensions/Fitment: This hanger is 1-7/8" wide so it will hold any Headset with a band of that size or smaller the diameter of the curve is Ø4-3/4" because that is the diameter of my Logitech Pro X headset. It will fit most of any headset.
Printing: I used Cura, 3 walls, 20% Infill, 0.2 layer height, and Tree Supports to hold the front lip just to be sure it would look good and it used barely any filament compared to regular supports in Cura. For some printers, it may be unnecessary (Don't take my word for it).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
