Thingiverse
Headphone Holder
by jimmysdiy
2
Downloads
2
Likes
0
Makes
Remix from- https://www.thingiverse.com/thing:3979058
Original Creator: Thingster
Remix Done By - jimmysdiy
I have an autonomous AI desk and did not want to use Screws to mound the headphone holder.
Therefore, I remixed the headphone holder from Thingster and added a horizontal wedge
Once printed, you'll simply install this between table board & metal frame. The wedge is 2.3mm and it will fit tight
If you opt to use screws, you can use with M4 countersink screws (ISO 10642).
Accomodates headphones with up to 40 mm wide headbands.
# Print Settings
Printer: Ender 3 4.2.2
Rafts: No
Supports: No
Resolution: .2
Infill: 20%
I also added gcode file if you'd like to use my settings
Original Creator: Thingster
Remix Done By - jimmysdiy
I have an autonomous AI desk and did not want to use Screws to mound the headphone holder.
Therefore, I remixed the headphone holder from Thingster and added a horizontal wedge
Once printed, you'll simply install this between table board & metal frame. The wedge is 2.3mm and it will fit tight
If you opt to use screws, you can use with M4 countersink screws (ISO 10642).
Accomodates headphones with up to 40 mm wide headbands.
# Print Settings
Printer: Ender 3 4.2.2
Rafts: No
Supports: No
Resolution: .2
Infill: 20%
I also added gcode file if you'd like to use my settings
jimmysdiy also publishes on
14 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
