Thingiverse
Headphone Wall Mount
31
Descargas
13
Likes
1
Makes
One size fits all headphone mount for a wall. Sticks out 70mm from wall, far enough for large headsets like Sennheiser HD6XX.
Uses a single 3.5mm diameter screw which is on the inside of the shape so that it's not visible. It is countersunk. Simply drill a hole, use a rawl plug and one 3.5mm screw. You might need to manually turn the screw using a screwdriver as a drill will struggle to reach inside this, or use an extension on your drill.
Super thin design so it prints quickly, just 4 lines on a 0.4mm nozzle. Due to curves/shape, stronger than needed, can barely flex the PLA part by hand.
Tested with Sennheiser HD6XX and Bose QC35 II.
Uses a single 3.5mm diameter screw which is on the inside of the shape so that it's not visible. It is countersunk. Simply drill a hole, use a rawl plug and one 3.5mm screw. You might need to manually turn the screw using a screwdriver as a drill will struggle to reach inside this, or use an extension on your drill.
Super thin design so it prints quickly, just 4 lines on a 0.4mm nozzle. Due to curves/shape, stronger than needed, can barely flex the PLA part by hand.
Tested with Sennheiser HD6XX and Bose QC35 II.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
