Headphones holder - Rack mounted

Headphones holder for rack.

I needed a holder for my studio headphones, that was close to the amp.

Of course you need to print 2 screws. This was split in this way so the parts are printable without supports.

The bracket has a slight offset, to leave the tower outside the case.
Bracket + Offset total distance is 8mm. Check if that it's enough for your case, if not, just extrude it as needed. The screw it's the same length as tower + bracket, if you extrude the bracket, I don't think you'll need to make the screw longer.

All printed using 0.2 layer height, pretty easy print.

With the holder I recommend using a good brim and print it the longest side on the bed. In that way you don't need supports, but the base it's pretty small. If you check my actual pictures, I had a problem almost at the end of the print, where the print lost adhesion. Fortunately it was almost done.

Fusion360 file with all the bodies is attached, so if you need to change something, feel free to :