Thingiverse
HeadPhones Stand
von anikiandy
33
Downloads
32
Likes
0
Makes
Saw something similar made of wood. Couldn't afford it.
I was able to print it on an Ender 5 without supports but the overhang at the top of the arc was a little too much and ended up with some non-adhered PLA.
If you can fit it, flipping it on it's side should yield better results.
I was able to print it on an Ender 5 without supports but the overhang at the top of the arc was a little too much and ended up with some non-adhered PLA.
If you can fit it, flipping it on it's side should yield better results.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
