Thingiverse
Headplay FPV battery case
by miharix
8
Downloads
4
Likes
0
Makes
Old battery of my Headplay FPV googles was bad.
I disordered the PCB and all smd components except the [10K voltage divider resistor](http://www.rcgroups.com/forums/showthread.php?t=1537992).
Then I flipped the black connector so I could connect it when the PCB was flat in the liberator.
Next the PCB was epoxy glued.
The battery is now [GENS ACE 4000MAH 7.4V 30C 2S1P HC 9](http://www.lipo.si/izdelek/G-30C40002S1PHC9/gens-ace-4000mah-74v-30c-2s1p-hc-9)
And the extended case is 3Dprinted.
There are 2 stl files. One is ca. 40% deeper then other.
The source files(FeeCAD) are for the smaller, so you can change the writing on the bottom.
I disordered the PCB and all smd components except the [10K voltage divider resistor](http://www.rcgroups.com/forums/showthread.php?t=1537992).
Then I flipped the black connector so I could connect it when the PCB was flat in the liberator.
Next the PCB was epoxy glued.
The battery is now [GENS ACE 4000MAH 7.4V 30C 2S1P HC 9](http://www.lipo.si/izdelek/G-30C40002S1PHC9/gens-ace-4000mah-74v-30c-2s1p-hc-9)
And the extended case is 3Dprinted.
There are 2 stl files. One is ca. 40% deeper then other.
The source files(FeeCAD) are for the smaller, so you can change the writing on the bottom.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!