MakerWorld
Decor
Go to Model
Heartlamp
53
Downloads
47
Likes
16
Makes
Anatomical heart-lampI used clear PLA for the heart component. Removing the support from the aorta is a bit tricky. I first loosened the entire support by carefully wiggling it, then used thin scissors through the brachiocephalic trunk to cut it into pieces. I then shook the remaining support out of the aorta. A knife might work as well.The heart can only be pushed onto the mount in one way. This can also be a bit tricky - trimming the edges slightly might help, but it worked fine for me. The model is certainly not perfect and I’d be grateful for any improved print profiles! :)If you like this profile, I’d really appreciate a boost!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
