Hearts on the Wall bookmark

HueForge print instructions: Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 66.62x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.72mmThe Max Depth is 2.2mm and the Actual Depth is 2.3mm Filaments Used: PLA BambuLab Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Grey Transmission Distance: 1 PLA BambuLab Basic Red Transmission Distance: 4This print uses 4 unique filaments Swap Instructions: Start with Black At layer #9 (0.72mm) swap to Dark Gray At layer #13 (1.12mm) swap to Grey At layer #20 (1.68mm) swap to Red for the rest.