Heat Insert Press from Mk4s to CORE One conversion leftovers

model by @Raging_H20_1439118 After converting the Mk4s to the CORE One I had a lot of leftover parts, so I made this heat insert press out of them. Feel free to remix this model.Parts reused:Old print bed2 x 8mm rods (from the X-Axis)4 x 8mm bearings (3 from the X-Axis, one leftover from the bed)4 x Rubber feet2 x idler pully pins29 x M3x10 screws8 x M3 nuts2 x M3x125 x M3x64 x M3 washersThings you need to get (Linked is what I got):Soldering Iron (https://amzn.eu/d/bNrLjni)Heat Inserts M3 x 5 x 4 (https://amzn.eu/d/4hSooH7)Retractable Keychain (https://amzn.eu/d/93SfgPU)Print Settings:Material: PETG/ABS/ASA0.2mm layers4 Walls5 top and bottom layers40% InfillOrientation of the parts should be correctYou will need supports on these surfaces of the "Rod holder bottom" and "Carriage front". Other parts should not require any support:If you print the bed with ASA or ABS I recommend scaling the X-Axis up to 100.7% to compensate for heat shrinkage: &nbsp