Thingiverse
Heatbed cable protector
by Matti55
13
Downloads
7
Likes
0
Makes
Protection cup for back frame of the printer and limit switch. Protects heatbed cable from rubbing against the sharp edges of the housing.
After printing apply double-site duct tape and press on the place.
My set: print speed 50mm/s, nozzle 0.4mm, layer 0.18mm, infill 25% Time:~0.45H
After printing apply double-site duct tape and press on the place.
My set: print speed 50mm/s, nozzle 0.4mm, layer 0.18mm, infill 25% Time:~0.45H
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
