heatbed-corner-v1

This is intended as a fastener in the corners of the heat-bed, to fasten a glass-bed on top of the heat-bed of a 3D-printer.

The two side holes are for M5 screws that can be threaded into the plastic. The length of the screws depends on the size of the glass-bed. The middle hole that goes to the spring is for an M3 screw, but is not threading into the plastic.

I recommend using ABS or any heat-tolerant material as this is connected under the heat-bed. On my corexy printer there is only three corners to not collide with extruder.

My printer is a Zonestar Z9M3 and the glass I put on the heat-bed is a hardened 6mm glass.

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/75HwumqhX9w