Thingiverse
Heattower - Temperature Test Tower - TTT
by Z3ALT
766
Downloads
355
Likes
4
Makes
UPDATE! NEW 3D-Printer Temperature-Test-Tower TTT
Changed and uploaded: 25.07.2018
3D Printer Heating Testtower (175°C-250°C in 5°C Steps)
Dimensions: 50x20x50mm (10 Testlayers)/ 50x20x5mm (1 Testlayer)
Set temperature change every 5mm!
If you dont know whether your printbed has enough adhesion with lower temps, use the TTT which start with a high temp first.
IMPORTANT:
Please make shure, that your printer prints at 175°C if you're using a version with 175°C.
Otherwise change and use a setting with a higher temperature at the 175°C piece!
EXAMPLE & MANUAL:
At 0.2mm resolution (layer height) you will need following temperature layers (change every 25 layers):
Example: 205-250.stl
from 1: 205°C
from 26: 210°C
from 51: 215°C
from 76: 220°C
from 101: 225°C
from 126: 230°C
from 151: 235°C
from 176: 240°C
from 201: 245°C
from 226: 250°C
Please comment, if you need some improvements.
Changed and uploaded: 25.07.2018
3D Printer Heating Testtower (175°C-250°C in 5°C Steps)
Dimensions: 50x20x50mm (10 Testlayers)/ 50x20x5mm (1 Testlayer)
Set temperature change every 5mm!
If you dont know whether your printbed has enough adhesion with lower temps, use the TTT which start with a high temp first.
IMPORTANT:
Please make shure, that your printer prints at 175°C if you're using a version with 175°C.
Otherwise change and use a setting with a higher temperature at the 175°C piece!
EXAMPLE & MANUAL:
At 0.2mm resolution (layer height) you will need following temperature layers (change every 25 layers):
Example: 205-250.stl
from 1: 205°C
from 26: 210°C
from 51: 215°C
from 76: 220°C
from 101: 225°C
from 126: 230°C
from 151: 235°C
from 176: 240°C
from 201: 245°C
from 226: 250°C
Please comment, if you need some improvements.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
