Heavy Spool Holder for Elegoo Centauri Carbon

Now, if you're anything like me, you will end up excitedly ordering a 3kg filament spool for your new Centauri Carbon only to find two reasons why it is never going to work.

1. The stock spool holder is too short
2. A longer holder wouldn't have enough support

Of course, people might tell you to get a roller, like a normal person. That would be the rational thing to do. SO, I made these:

1. Longer spool holder
2. Support for the spool holder

Printed everything at the 0.2 Strength setting with double brim, with supports for the holder itself. There's a bout 1mm of slack below the base of the stand, I put a rubber pad there, a modest stack of post-its will also do. It is actually somewhat functional, I didn't expect that.

Disclaimer: I'm neither a designer nor an engineer, so probably find a better solution. Tips are welcome though.

Also, I totally mutilated this existing spool holder:
https://www.printables.com/model/1210787-bearing-spool-holder-for-elegoo-centauri-carbon