Thingiverse
Heel Straps
von BearlyRecognized
1
Downloads
1
Likes
0
Makes
TPU 98A - Base Strap (100%), Rachet and Cam Lock Straps (100%)
TPU 85A - Rachet Shock Block (100%), Strap Sheild (100%)
TPU Ninja Flex - Rachet Lock Spring (100%), Comfort insert (15 - 20%)
PLA or Other (PLA Tested) - Everything else (100%)
Requires 8 t nuts (and corresponding bolts), m3 - 45mm (10) and lock nuts.
Optional - Tnuts in cam and rachet strap for increased life span.
It is recommended to use heat to insert the Tnuts for a flush mount.
INFO - Straps tested at 250lb + 40lb board, jumping, falling, and crashing approved.
I AM NOT RESPONSIBLE FOR ANY INJURY RESULTING FROM USING THESE. USE AT OWN RISK. CHECK LAYER ADHESION!!!!.
TPU 85A - Rachet Shock Block (100%), Strap Sheild (100%)
TPU Ninja Flex - Rachet Lock Spring (100%), Comfort insert (15 - 20%)
PLA or Other (PLA Tested) - Everything else (100%)
Requires 8 t nuts (and corresponding bolts), m3 - 45mm (10) and lock nuts.
Optional - Tnuts in cam and rachet strap for increased life span.
It is recommended to use heat to insert the Tnuts for a flush mount.
INFO - Straps tested at 250lb + 40lb board, jumping, falling, and crashing approved.
I AM NOT RESPONSIBLE FOR ANY INJURY RESULTING FROM USING THESE. USE AT OWN RISK. CHECK LAYER ADHESION!!!!.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
