Thingiverse
Hefty Surface Magnet
von marmotjr
0
Downloads
1
Likes
0
Makes
Just a nice magnet for hanging blueprints on my CNC machine. Would work well on a fridge or other surface too.
Each magnet uses 2 12mmx3mm rare earth magnets. They are held internally, so you MUST add a PAUSE command in the gcode at the layer prior to the voids getting covered up.
Each magnet uses 2 12mmx3mm rare earth magnets. They are held internally, so you MUST add a PAUSE command in the gcode at the layer prior to the voids getting covered up.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
