Heli Flyer V1

Heli Flyer V1 - A hand pull launcher that prints in less than 1 hour. Features:Very easy to printEasy assembly (1 dab of super glue required)Under 1hr print timeNo support neededFun for kids and big kidsSimple and effective rack and pinion designThe propeller/rotor launches over 15 feet in the air with a good pullOnly uses 20g of filament per Heli Assembly:Push the skids into the body until fully seated. Face the flat sides inward for the best aesthetic.Add a small amount of super glue to the pin of the ‘Gear’ and push the ‘Propeller’ in place.Allow the glue to fully set, or use some activator before testing it out.Usage:Insert the ‘Rack’ into the ‘Body’. There is a small slot in the ‘Rack’ and a small protrusion in the ‘Body’ to help guide the ‘Rack’ into the correct place.Drop the ‘Propeller’ onto the pin in the centre of the ‘Body’Push the ‘Rack’ to the forward positionPull it back as fast and straight as you can using the ring-pull at the rear. This is great fun for kids and is eas