Helldivers 2 Factory Strider. Modified for prints!

A modified to print model from Helldivers 2 of the Automaton Factory strider.A lot of the modifications involved blocking through the neck and leg joints so taht the actualy modelled linkage wasnt the thing holding them together.This means that it is a lot stronger to remove the supports without breaking the legs off. The original model is by Arrowhead Game studios and modifications done by me. Note 1 that you can flip the model upside down which I found resulted in easier to remove supports as the underchin guns are fragile when remove supports when right side up. Flipping upside down to print used a bit more filament and took a slightly longer but safer to remove supports. Note 2 Going too small on the print can lead to the guns becoming easily breakable as the barrels become very thin. The one in the photos is 110mm tall however I would not go lower than 60mm tall for the above reason.