Thingiverse
Helmet Stand
door pmorrell
102
Downloads
97
Likes
0
Makes
Created a simple helmet stand within Tinkercad to hold the cosplay helmets I have been making.
Four files are included:
1. Helmet Rod.stl which is the support bridge between the base and the upper contact. Measures 330 mm tall (13 inches) and is .6mm in diameter smaller than the other two files. From which my print provided a tight fit where no adhesives were required. Z axis should be shortened or lengthened depending on your height requirements.
2. Helmet Upper.stl is to be used as the contact piece for the inside of your helmet.
3. Helmet Base.stl is the base structure which measures 152 mm (6 inches) wide.
4. GF Helmet Base.stl is the 'Helmet Base.stl' file with an added 'Fox Hound' logo
I made this with the intent of holding my 'Gray Fox' helmet that the talented @Toribor kindly provided. https://www.thingiverse.com/thing:2557764
Total print time was around 13 hours with standard draft settings. I hope others find use in this small project.
Four files are included:
1. Helmet Rod.stl which is the support bridge between the base and the upper contact. Measures 330 mm tall (13 inches) and is .6mm in diameter smaller than the other two files. From which my print provided a tight fit where no adhesives were required. Z axis should be shortened or lengthened depending on your height requirements.
2. Helmet Upper.stl is to be used as the contact piece for the inside of your helmet.
3. Helmet Base.stl is the base structure which measures 152 mm (6 inches) wide.
4. GF Helmet Base.stl is the 'Helmet Base.stl' file with an added 'Fox Hound' logo
I made this with the intent of holding my 'Gray Fox' helmet that the talented @Toribor kindly provided. https://www.thingiverse.com/thing:2557764
Total print time was around 13 hours with standard draft settings. I hope others find use in this small project.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
