Thingiverse
Helmet Wall Mount
von makeitnerdie
8
Downloads
17
Likes
0
Makes
The files are saved in the orientation to print them. The wall mount needs to be printed on an angle to ensure strength.
***IF YOU PRINT THE WALL MOUNT FLAT, IT WILL SNAP!!***
I've had a few fail on me only when it was printed flat. I hold no responsibility if your print fails.
The sections fit a 3/4" PVC pipe in them. Cut the PVC to the lengths that you need them. Secure the pipes with a screw with the provided holes. Add a piece of velcro to the top part and the inside of your helmet to keep it in place.
***IF YOU PRINT THE WALL MOUNT FLAT, IT WILL SNAP!!***
I've had a few fail on me only when it was printed flat. I hold no responsibility if your print fails.
The sections fit a 3/4" PVC pipe in them. Cut the PVC to the lengths that you need them. Secure the pipes with a screw with the provided holes. Add a piece of velcro to the top part and the inside of your helmet to keep it in place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
