MakerWorld
Electronics
Voir le modèle
Helping Hand - One Finger Operation
15
Téléchargements
20
Likes
2
Makes
DescriptionDo you hate alligator clips as much as me? then this helping hand is for you!Version 1.2Two upgrades in this version:High temp O-rings for better grip. The grip on V1.1 wasn't good enough. Two O-rings top and bottom provide the necessary holding power for wires and components.Thicker base, I find that when adjusting the rotation its hart to grab on the thin base, I made it thicker for easy grip. the magnets are now integrated in the base. Use a wider spring!In the V1 BOM I used: 50mm length, 6mm outer diameter, 0.4mm spring.The spring get stuck between the threaded rod and the bottom part, preventing smooth up and down motion. In V1.1 I made the bottom part in to prevent it, a bigger diameter spring (8-10mm OD) will slide on the bottom part preventing jamming BOMAll parts from V1.130mm OD and 25 mm OD, 2mm thick O-rings1 - M5 lock nutPrintingThere are two stops to make when printing, one for the magnets, second for the M5 lock nut in the top part.AssemblyAlmost the same
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !