Thingiverse
Heltec 12-16s BMS Case
di nate_syd
4
Download
7
Likes
0
Makes
To house the 12-16s BMS from Heltec
Printed in ASA for temp, the BMS gets screwed into the 4 square pads - so they'll need to be drilled out & then screw the BMS in place.
Set perimeters to 10, to make the squares that the lid screws into solid, no supports or anything else required.
Printed in ASA for temp, the BMS gets screwed into the 4 square pads - so they'll need to be drilled out & then screw the BMS in place.
Set perimeters to 10, to make the squares that the lid screws into solid, no supports or anything else required.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!