Thingiverse
Heltec Meshtastic V1 Case Button
door neverhart
0
Downloads
0
Likes
0
Makes
Really liked the Meshtastic case by jameslee522 (thing: 4979450) and had printed out the V1 case with flex buttons for the PRG and RST buttons built in to the case, but one broke and the V2 case buttons didn't fit this case, so I whipped these up in Fusion.
Very basic captured button that's the perfect height to avoid squashing the Heltec board in the box but still clicks perfectly on my print. The button itself is very slightly rectangular (4.5mm x 5mm) so the shelf that holds the button in the body needs to be aligned to the free sides of the hole. (If that sounds confusing, just keep rotating the button in the hole until it seats.)
Button is fairly low profile, sits about 1.25mm proud of the case on my print.
Hope someone finds it useful!
Very basic captured button that's the perfect height to avoid squashing the Heltec board in the box but still clicks perfectly on my print. The button itself is very slightly rectangular (4.5mm x 5mm) so the shelf that holds the button in the body needs to be aligned to the free sides of the hole. (If that sounds confusing, just keep rotating the button in the hole until it seats.)
Button is fairly low profile, sits about 1.25mm proud of the case on my print.
Hope someone finds it useful!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
