Heltec V3 D3 Digivice

This is designed as a Heltec V3 case in the style of a D3 Digivice. I am incredibly new to any 3D modeling or editing of any sort, so some is left to be desired, but I wanted this to exist and it didn't, so I made it.

My printer is not calibrated super well so I do best prints that start with a completely flat surface, thus the lack of texture on the front and back exterior. I'm sure someone could remix this to add the texture back and make it cooler.

I may tweak this more over time as I don't like the sharp edges and a couple exterior spots on the sides don't align perfectly, but for now it's functional and I like what I have so far.

Applicable notes from remix source:
This model is very tight and was tweaked to fit a specific 3000mAh battery and the Heltec OLED LoRa V3 Board (863-928 MHz), (433-510MHz). The case is a snap fit, but there needs to be some attention paid to the location of the power leads from the battery so that they are not in the way.