Thingiverse
Heltec32 Meshtastic Case
di B8B8
47
Download
49
Likes
0
Makes
Case for a Heltec LORA32 V2 development board.
meshtastic.org
Parts:
4x M3x25 socket head cap screw
4x M3 Nut
1x 1/4"-20 Nut
1x Heltec Lora32 V2 development board
1x small lipo battery
1x GX12 Aircraft connector
1x 90 degree micro USB Cable
1x switch
https://www.amazon.ca/gp/product/B07Y895DP3
https://www.amazon.ca/gp/product/B078Y2Z8NK
https://www.amazon.ca/gp/product/B07MR3CQCC
Wiring:
Cut the 90 degree USB cable roughly 2 inches from the tip. Next Solder each of the 4 coloured wires to GX12 connector. Make sure you MATCH the wire colours to the same pin numbers on the male and female GX12 connector. This is just a normal usb cable with a special/secure connector between each end.
The switch on the side of the device is just an in-line switch to physically disconnect the battery from the board.
meshtastic.org
Parts:
4x M3x25 socket head cap screw
4x M3 Nut
1x 1/4"-20 Nut
1x Heltec Lora32 V2 development board
1x small lipo battery
1x GX12 Aircraft connector
1x 90 degree micro USB Cable
1x switch
https://www.amazon.ca/gp/product/B07Y895DP3
https://www.amazon.ca/gp/product/B078Y2Z8NK
https://www.amazon.ca/gp/product/B07MR3CQCC
Wiring:
Cut the 90 degree USB cable roughly 2 inches from the tip. Next Solder each of the 4 coloured wires to GX12 connector. Make sure you MATCH the wire colours to the same pin numbers on the male and female GX12 connector. This is just a normal usb cable with a special/secure connector between each end.
The switch on the side of the device is just an in-line switch to physically disconnect the battery from the board.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
