Heltek V3 Lora Slimline Case

####Heltek V3 Lora Slimline Case

This case was designed to be pocketable and discrete. The case uses three M3 threaded heat-set inserts for a secure fit! The battery compartment fits a 1000 mah 3.7 lipo from MakerFocus found on [Amazon here](https://www.amazon.com/MakerFocus-Rechargable-Protection-Insulated-Development/dp/B07CXNQ3ZR/ref=sr_1_2?crid=1H17AJBXBNIX1&keywords=1000%2Bmah%2Blora%2Bbattery&qid=1706911012&sprefix=1000%2Bmah%2Blora%2Bbattery%2Caps%2C80&sr=8-2&th=1) for up to an 8 hour battery life.

The current setup will require you to trim the small coax cable down to 35 mm and solder the coil antenna to the cable. I used some heat shrink to secure the solder connection and a dab of hot glue internally to keep it from bouncing around. The chasis includes two posts that can be trimmed off after printing. This helps avoid warping on the overhangs.