Hema Feder Waster

I was inspired by Funderaren-s design for the snow pole waster but because in my country snow is rare, I had to re design it around, 25,3 mm outside and 20 mm inside diameter drinking water pipe. Inside the pipe I put a 17 mm diameter wooden dowel that i thickened up whit duck tape to be a good sturdy fit. Inside of the pommel I put two 21mm diameter and 15 mm tall weights made out of lead to put the balance point further back.
The handle and the pommel was printed on a 0.28 mm layer hight and a 100% infill out of PLA + from esun
and the shill was printed on a 70% cubical infill whit the same layerhitght out of Petg also from esun
the final dimensions:
Length: 130cm
weight : 665 g
blade from the shill up : 92 cm
drinking pipe: 1 m
wooden inside: 1.3 m
handle from the guard down: 27.5 cm
If something is not sure just ask me in the comments.