Hemera Fan + Sensor Mount (BLTouch and Inductive Probe)

This is a remix of the fan mount from Baphomet. It is meant for a 5015 radial blower fan. I have included 2 different mounts, depending on the type of sensor you have. I used a 12mm (diameter) inductive probe but found it was inconsistent and have since switched to a BLTouch. They're both mounted to the side of the motor which should clear most printer frames.

The fan is positioned similarly to Anet A8 so I've found that some of those fan ducts will work, but they're often a little too short. If you use longer ones, they tend to work pretty well.

STEP files included :) cc-sa

# Configuration

CAUTION: You MUST test the Z values yourself and probe configuration. These are merely meant to be a starting. I can't be held responsible if you mess up your machine.

For BLTouch I'm using a Probe Offset of
`X63.00 Y-30.00 Z-3.50`

For the Inductive Probe I used
`X63.00 Y-10.00 Z-2.6`