Hemera mount CR6

This is a working Beta Release, these can be printed at .12 at least for the fan duct. I have included the firmware as well as the configuration files. Feel free to contribute to helping further modify the CR6 and other printing ventures visit my Patreon or PayPal me with a note.
The included firmware will be for both CR6 and CR6 Max, with BTT motherboard and display, as well as BTT board with Stock display, Stock boards with stock display.

Hardware:
-Hemera DD or Bowden
-M3 bolts and nuts(kit on amazon are cheap and always great to have laying around for tinkering)
-Lengths of PTFE tubing( I used Capricorn)
---Optional---
- BTT Runout sensor
-Stock filament runoout for CR6(remove from stock housing, place in the one on the mount)
-Neopixels

Mounting instructions:

Remove the stock hot end assembly leaving the plate attached to the gantry.

1) Place the mount with the transfer board on the plat first, it will need 2-M3x6mm and 2-M3x16mm.( Wait until you have all the