HEPA compatible face mask with active filter

A remix of https://www.thingiverse.com/thing:4222563


It's a little taller so that it's easier to adapt it to your own face. To do this:

* Print in PLA
* Put in boiling water for 30 seconds
* Push it to your face (It will be warm but it will not hurt).

Optionally, put silicone sealant around it.

The filter is designed to hold a 5V or 12V 50mm fan to help with breathing.

Instructions on how to make the filter "cartridge" can be found at https://imgur.com/gallery/l01Za8E



If you want to see my other work, check out https://robots-everywhere.com/