Thingiverse
Hephestos Support
von jrho
26
Downloads
16
Likes
1
Makes
No matter how tight You tighten the bolts in the bed against the z axis frame it always seems to move to easy! - With this support the z axis stops moving! - Its not necessary to put one in each side - the frame is so stiff that one support is enough.
I use a 12mm plywood sheet that I have fastened the printer and support to, with the shown screws.
I use a 12mm plywood sheet that I have fastened the printer and support to, with the shown screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
