Thingiverse
Hero Session 5 SourceOne (v3) Camera Butter
door mouseFPV
5
Downloads
3
Likes
0
Makes
Remixed this. Few changes:
1) added about .75 mil of height. The original is a tight fit and holds with friction, problem is it stretches a tad and the vertical bars on the face "warp" inwards. Not a big deal, it just bothered me.
2) pulled face forward about 1.75mm (after the drop down) to make room for a camera butter ND stick on filter.
3) Point two caused the corners of the mount to show in a superview frame, so I cut out the corners.
4) points one and 2 made the session fit a little too losely for my likeing and it was no longer a trustworthy friction fit. Added a slip on band to help hold it all together. You can always use a rubber band, but, meh.
5) point 4 added about 1.5g, so I cut a square out of the back to reduce weight.
1) added about .75 mil of height. The original is a tight fit and holds with friction, problem is it stretches a tad and the vertical bars on the face "warp" inwards. Not a big deal, it just bothered me.
2) pulled face forward about 1.75mm (after the drop down) to make room for a camera butter ND stick on filter.
3) Point two caused the corners of the mount to show in a superview frame, so I cut out the corners.
4) points one and 2 made the session fit a little too losely for my likeing and it was no longer a trustworthy friction fit. Added a slip on band to help hold it all together. You can always use a rubber band, but, meh.
5) point 4 added about 1.5g, so I cut a square out of the back to reduce weight.
mouseFPV publiceert ook op
19 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
