Heroic Inspiration Token / Coin

Version 2 now released - suitable for 0.4mm nozzle printing and ability to add weight with optional 40mm washers: https://makerworld.com/en/models/1252303-heroic-inspiration-token-coin-v2#profileId-1275055 This is a remix of darkcammo's great D&D Inspiration Token/Coin over on Thingiverse - they had a lovely 2-sided coin that would be difficult to print without supports or artifacts - so I have sliced one of the 2-sided coins in half to enable easier printing and made a simple alignment tool to enable gluing the 2 pieces together after printing easier. I highly recommend a 0.2mm nozzle for the coin halves to enable the text to be as legible as possible - your experience with a 0.4mm nozzle will vary. The print profile is setup to create 4 coins in total (8 halves) - the seems are aligned so that if they are glued back to back, the faces on each side are the correct orientation. You can use a 0.4mm nozzle for the alignment tool and 0.2mm layer height to save time on that however. Th