Thingiverse
Herrnhuter Stern
von T70E
336
Downloads
206
Likes
16
Makes
The Herrnhuter Stern is a typical Christmas decoration found all over Germany. The originals were made out of paper and held together by small pins. This one is a bit different but has the same overall style.
The models are designed to be printed in Vase/Surface mode with continuous extrusion. This makes it printable on almost any machine. I printed them using red Colorfab XT because its a good color and a bit more heat resistant. Heat resistant is good because I used hot glue to hold all the parts together and have a small lightbulb mounted in the middle.
You'll need to print 17 of the larger 4 sided points and 8 of the smaller 3 sided points for a complete Herrnhuter Star. I had no problems printing these and overall print time was about 17 hours.
Note: Printing 17 larger 4 sided points will leave a small opening to place a small light bulb. To fully enclose the star you will need to print 18 total.
The models are designed to be printed in Vase/Surface mode with continuous extrusion. This makes it printable on almost any machine. I printed them using red Colorfab XT because its a good color and a bit more heat resistant. Heat resistant is good because I used hot glue to hold all the parts together and have a small lightbulb mounted in the middle.
You'll need to print 17 of the larger 4 sided points and 8 of the smaller 3 sided points for a complete Herrnhuter Star. I had no problems printing these and overall print time was about 17 hours.
Note: Printing 17 larger 4 sided points will leave a small opening to place a small light bulb. To fully enclose the star you will need to print 18 total.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
