Thingiverse
Hex Bit Holder Angled (18 bits)
2
Downloads
1
Likes
0
Makes
Made a small Hex Bit Holder Angled (18 bits) that can be screwed down with #6 screws to a drawer or table base.
User parameter if available in the Fusion 360 file for the size of the holes. Feel free to adjust as needed for a tighter or looser fit depending on accuracy of your 3d printer and the bits you typically use! Default is slightly looser than universal standard 6.3mm hex diameter at 7.2mm so you're not fighting to put bits in and out.
User parameter if available in the Fusion 360 file for the size of the holes. Feel free to adjust as needed for a tighter or looser fit depending on accuracy of your 3d printer and the bits you typically use! Default is slightly looser than universal standard 6.3mm hex diameter at 7.2mm so you're not fighting to put bits in and out.
admiralindustries also publishes on
6 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
