Thingiverse
Hex bit holder - SAE
von Allenm00
0
Downloads
0
Likes
0
Makes
Remove hex holder holder built in support after printing. No additional supports needed for this part.
Remove hex bit pin midpoint support after printing.
This was designed for Hercules SAE hex bits (sku 58269).
BOM
M2 x L3 x D3.2 thread insert
M2 x 30 SHCS
0.4 x 5 x 30mm compression spring
may need to scale by 2540%
Remove hex bit pin midpoint support after printing.
This was designed for Hercules SAE hex bits (sku 58269).
BOM
M2 x L3 x D3.2 thread insert
M2 x 30 SHCS
0.4 x 5 x 30mm compression spring
may need to scale by 2540%
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
