Hex Honeycomb Side Table / Shelf

A small table/shelf with a hex/honeycomb top for an good design and strength-to-weight ratio. The legs feature a chamfer at the top, taper towards the middle, and widen again at the bottom. This improves stability without without using supports.I printed the big version in PETG (as shown in photos) for higher strength and weight, using 5 wall lines. PLA/PLA+ also works depending on the intended load – adjust settings as needed. I recommend 3-5 wall lines depending on strength requirements. Increasing infill can further improve stability. Versions:VersionHeightTop PlateShelf_Normal.3mf110 mm~250 × 250 mm, ~10 mm thickShelf_Big.3mf250 mm~250 × 250 mm, ~10 mm thick If you want to modify the design feel free. Just Download the included .STEP files and create your own remix.