Hex Spice Rack

This is a simple spice rack in two sizes. Using hexagon grid pattern to reduce filament usage. There are 2 4mm countersunk screw holes.

One is 220mm wide which can be printed straight on a lot of print beds, or on most if printed diagonally. For print beds of 150mm you'll have to scale it down slightly.

The larger one fits diagonally on a 300mm print bed, but turn off any skirt, brim, etc as that'll push the model beyond the print boundary.

Printed with 2 walls of 0.8mm thickness means zero infill is needed, same with the base. 0.4mm "top/bottom" thickness gives you two base layers and two upper layers separated by just 4 layers of infill, so I went with 20% "lines" type infill for the base.