Thingiverse
Hexagon Fan Shroud
von gyronictonic
68
Downloads
45
Likes
1
Makes
Fan shroud for the Hexagon Hotend, similar to the E3D Hotend.
Uses a 25 x 25 mm cpu fan
The profile is small, double check the clearance on your printer's head mount before printing. It's been optimized to use hotend mounts from the VertX extruder
http://www.thingiverse.com/thing:137806
**NOTE**
Will not fit on the Hexagon used on the Lulzbot Mini. Lulzbot uses a custom Hexagon heatsink that's smaller (4 fin heatsink) vs the original (8 fin heatsink).
Uses a 25 x 25 mm cpu fan
The profile is small, double check the clearance on your printer's head mount before printing. It's been optimized to use hotend mounts from the VertX extruder
http://www.thingiverse.com/thing:137806
**NOTE**
Will not fit on the Hexagon used on the Lulzbot Mini. Lulzbot uses a custom Hexagon heatsink that's smaller (4 fin heatsink) vs the original (8 fin heatsink).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
