Thingiverse
Hexagon Toothbrush Stand
von dainon
3
Downloads
2
Likes
0
Makes
###Hexagon Toothbrush Holder
This toothbrush holder has a 17mm diameter cylindrical cutout for each toothbrush. It appears to not have any support for the toothbrush, but it supports very well. The toothbrush is easy to remove and replace from the stand. Two 26.4mm diameter x 3.1mm depth holes are on the bottom to add rubber pads to prevent sliding. All angles are printable without supports. Holds 2 toothbrushes.
### Dimensions (mm)
Stand: 135 x 60 x 91.3
Rubber Feet Holes (2x): 26.4 diameter x 3.1 deep
###This Print
Resolution: 0.4mm Nozzle
Layer Height: 0.2mm
Filament: PETG, Hatchbox Clear
Infill: 20%
Supports: No
This toothbrush holder has a 17mm diameter cylindrical cutout for each toothbrush. It appears to not have any support for the toothbrush, but it supports very well. The toothbrush is easy to remove and replace from the stand. Two 26.4mm diameter x 3.1mm depth holes are on the bottom to add rubber pads to prevent sliding. All angles are printable without supports. Holds 2 toothbrushes.
### Dimensions (mm)
Stand: 135 x 60 x 91.3
Rubber Feet Holes (2x): 26.4 diameter x 3.1 deep
###This Print
Resolution: 0.4mm Nozzle
Layer Height: 0.2mm
Filament: PETG, Hatchbox Clear
Infill: 20%
Supports: No
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
