Thingiverse
Hexagonal Incense Cone Mold
von wriz
22
Downloads
34
Likes
0
Makes
Simple two-part mold for making incense cones!
_________________________________________________________
How to use:
- Hold the two halves together with your fingers in one hand and stuff the mold as tightly as possible with the other.
- (Optional but recommended for improved airflow/backflow) Carefully poke a hole through the center of the cone with a toothpick or a thin nail, ~3/4 of the way through.
- Wiggle/twist the two mold halves and separate them.
- Carefully finesse the tip of the cone (it tends to stick in the mold and break) until it comes loose.
- Repeat until you're out of putty!
_________________________________________________________
How to use:
- Hold the two halves together with your fingers in one hand and stuff the mold as tightly as possible with the other.
- (Optional but recommended for improved airflow/backflow) Carefully poke a hole through the center of the cone with a toothpick or a thin nail, ~3/4 of the way through.
- Wiggle/twist the two mold halves and separate them.
- Carefully finesse the tip of the cone (it tends to stick in the mold and break) until it comes loose.
- Repeat until you're out of putty!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
