Thingiverse
Hexapen Stand
von makersendinfo
15
Downloads
18
Likes
0
Makes
We'll print out a bolt to support it... might as well.
It's a hex nut--OR IS IT? It is, it's just been drilled out to hole up to six pen-like objects. Each holder is ~1/2" so it'll hold fairly fat pens/tools. We're looking forward to painting this one up, we'll post a photo when we do. Good chance to practice the ol' airbrush.
It's a hex nut--OR IS IT? It is, it's just been drilled out to hole up to six pen-like objects. Each holder is ~1/2" so it'll hold fairly fat pens/tools. We're looking forward to painting this one up, we'll post a photo when we do. Good chance to practice the ol' airbrush.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
