Thingiverse
Hexatile: Modular Wall System
por jerrod
25
Descargas
21
Likes
0
Makes
Almost three years in the making, most of these tiles were printed from the last remaining filament left on the spool. So, it's taken awhile to amass the amount needed to create something worth hanging.
This was inspired by the Veil Modular Partition System I saw at a MOMA store in San Francisco a few years back and the bleak look of cinder block in my basement.
https://bxclvr.com/veil-modular-partition-system
To connect, I designed the nodes of each tile to accept 5/16" clear flexible tubing (I had some scrap on hand). Cut tubing connectors to about 0.5-0.625" and insert into the holes. This allows you to connect the tiles in either direction. For wall mounting, I simply used command strips in the areas I felt needed some support.
Have fun and post pictures.
This was inspired by the Veil Modular Partition System I saw at a MOMA store in San Francisco a few years back and the bleak look of cinder block in my basement.
https://bxclvr.com/veil-modular-partition-system
To connect, I designed the nodes of each tile to accept 5/16" clear flexible tubing (I had some scrap on hand). Cut tubing connectors to about 0.5-0.625" and insert into the holes. This allows you to connect the tiles in either direction. For wall mounting, I simply used command strips in the areas I felt needed some support.
Have fun and post pictures.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
