Thingiverse
Hexibase Inspired Smart Lamp
10
Downloads
8
Likes
0
Makes
Youtubes Hexibase Inspired Smart Light Shade
Lower Base Section i used 0.28 layer height. 4% Infill, Black PLA.
Midsection Shade- Geeetech Transparent Filament. This section Must be sliced with Prusa Slicer 2. 2 perimeters, 3D Honeycomb 20%. The Gcode i used was made for the Ender 3 Pro, the ender 3 profile for Prusa Slicer 2 and i included this with the collection
0.20 Layer Height. This includes a raft like brim 4 layers high to help reduce or eliminate any warping. Any clicking of the extruder after the first few layers means you need to replace your nozzle as this prusa gcode is quite fast on some sections and needs a clean unclogged nozzle.https://youtu.be/a1kQcR3Gtk8
Top cap 0.28 layer height. 4% Infill, Black PLA
The STL in thingiverse show ghosting of previous edits and Boolean Subtractions. The STL when imported into slicer software are clean, and the prints show no ghosting of previous structural elements.
Depending on the light fitting and bulb size you can s
Lower Base Section i used 0.28 layer height. 4% Infill, Black PLA.
Midsection Shade- Geeetech Transparent Filament. This section Must be sliced with Prusa Slicer 2. 2 perimeters, 3D Honeycomb 20%. The Gcode i used was made for the Ender 3 Pro, the ender 3 profile for Prusa Slicer 2 and i included this with the collection
0.20 Layer Height. This includes a raft like brim 4 layers high to help reduce or eliminate any warping. Any clicking of the extruder after the first few layers means you need to replace your nozzle as this prusa gcode is quite fast on some sections and needs a clean unclogged nozzle.https://youtu.be/a1kQcR3Gtk8
Top cap 0.28 layer height. 4% Infill, Black PLA
The STL in thingiverse show ghosting of previous edits and Boolean Subtractions. The STL when imported into slicer software are clean, and the prints show no ghosting of previous structural elements.
Depending on the light fitting and bulb size you can s
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
