hi capa odin speedloader adapter

requires, ideally:
2x small springs
1x m3x20mm screw
1x m3x16mm screw

6/7/23: updated the geometry a lil bit, should be a little smoother now.

supports only on bed, lay the lever on the flat side, obviously. do at least 1.5mm walls for strength, i printed in 0.2mm layer height, 20% infill, overture PLA+ with no problems.

Odin speedloader to hi capa mag adapter. designed completely from scratch, inspired by blowback masters and airtac. I haven't ever seen one of those in real life and they cost like $40+ shipped, so i made my own. works flawlessly with army and WE mags, havent tried TM, prowin, AW, etc. might work for you, might not, probably will though.

loads bbs from the top, ensuring that there's no gaps and you don't have to fiddle with the tiny little follower or hold a thumb loader at the perfect angle. just slap a mag in there, crank it a couple times, and you're good. try not to over load your mags or you can strip your odin gears. that's on you.

has bb retent