High & Dry

This is a stepped holder to lift the back of your dish drying rack so the water drains into the sink.

I created this because the sink in the break room where I work has a lip which causes the rack to tip away from the sink and the counter is always wet. This way it drains directly into the sink.

I didn't know how high to lift the rack, so I made it stepped - the steps are at 10mm increments. Happy accident it looks vaguely like a wave.

It's a very rough design, clearly, but it works pretty well. Very well actually.

Added a version 2. It has roundovers on the front and rear edges. I noticed the first one chipped on the back edge, and could pinch a finger on the front edge (comments from people at work). Printed v2 with no supports, curves came out fine.